Trouble with 12V Relay attached to Pump - Arduino MEGA2560

I have attached to my Arduino a 2 Channel 12V Relay. Currently the red light on the Relay is working as my program switches LOW and HIGH every 5 seconds, so I know it's communicating. My 12VDC/AC power supply is plugged in the + is spliced in through the orange wire connected to the COM2. On the NO2 I have the +(pos) going to the pump. The -(neg) of the pump is connected to the power supplies -(neg). For some reason I get no response from the NO2 switching on or off. When the red light on the

Control a Pump with Arduino (Lesson #15)

Can't turn on 12v relay with output pins - General Electronics - Arduino Forum

How to use 12V Relay module with Arduino to control High Voltage Devices

Trying to connect 12V DC irrigation pump using Relay and power supply - Motors, Mechanics, Power and CNC - Arduino Forum

Arduino Mega is a microcontroller board based on the ATmega2560

Trying to connect 12V DC irrigation pump using Relay and power supply - Motors, Mechanics, Power and CNC - Arduino Forum

12v Relay issue - Hardware - Arduino Forum

Arduino - 4-Channel Relay Module

Issues with 12v and 12v relay to power a pump - Motors, Mechanics, Power and CNC - Arduino Forum

Arduino Mega 2560 Microcontroller Rev3 - RobotShop

DIY W220 PSE Central Locking Repair with an Arduino

5-12V DC pump doesn't start through relay - Project Guidance - Arduino Forum

Issues with 12v and 12v relay to power a pump - Motors, Mechanics, Power and CNC - Arduino Forum

12v Relay issue - Hardware - Arduino Forum