No 5V+ from Arduino Uno R3 - Motors, Mechanics, Power and CNC - Arduino Forum

My son was using his Elegoo kit I got him. He had done lesson 3 (hardwire an LED), and was doing lesson 4 and could not get it to work. I then plugged in my Arduino Uno R3 to see if it was the Arduino. Same result. So I got out my volt meter, and I'm only getting a few millivolts between the V5 pin and GND. It's possible something was wrong with his circuit that fried the regulator on his board, and then when I plugged mine it it fried mine also? Anyway, I should always get +5 out of the

Stepper motors not responding - Motors, Mechanics, Power and CNC - Arduino Forum

Prevent/ eliminate noise/interference in project - General Electronics - Arduino Forum

Arduino Uno Breadboard Tray By Sdhuk Download Free STL, 47% OFF

Stepper Motor Setup Trouble Shooting CNC Shield V3.0 - AccelStepper.h - Motors, Mechanics, Power and CNC - Arduino Forum

Need Help In Arduino Uno, L298N and Dc Motor - #13 - Motors, Mechanics, Power and CNC - Arduino Forum

Need Help In Arduino Uno, L298N and Dc Motor - #13 - Motors, Mechanics, Power and CNC - Arduino Forum

SOLVED] Bi-directional motor control with two mosfets? - General Electronics - Arduino Forum

Arduino Uno Breadboard Tray By Sdhuk Download Free STL, 47% OFF

Uno - Using 5v and 3.3v pins at the same time? - General Electronics - Arduino Forum

main@

Help with connecting CNC shield - Motors, Mechanics, Power and CNC - Arduino Forum

Arduino Uno Breadboard Tray By Sdhuk Download Free STL, 47% OFF

Stepper motors not responding - Motors, Mechanics, Power and CNC - Arduino Forum

Arduino Uno Breadboard Tray By Sdhuk Download Free STL, 47% OFF

Arduino Uno Breadboard Tray By Sdhuk Download Free STL, 47% OFF